Ledger boards which lend strength and support to a deck by connecting it to a house must be installed on a virtually flat surface.
How to attach ledger board to siding.
Learn the tools techniques materials and fasteners to properly install a deck ledger board arguably a deck s single most important connec.
Nail undersill trim j channel will also work over the bottom cut using 11 gauge aluminum nails.
Fasten the ledger board with 1 2 inch bolts and washers.
Step 5 attach ledger board.
Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location.
Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck.
Then cut away the siding.
Install the ledger between the rim joists and fasten it to the house with 3 inch decking screws.
If necessary create spacers by attaching pieces of decking to the top side of the frame that goes against the house.
Slip the flashing under the siding so it will cover the ledger board.
I want to attach the ledger board directly into the hardiboard siding of the garage with lag screws using washers as spacers for drainage between the ledger and the siding.
Secure flashing with galvanized nails.
The ledger board is a horizontal framing member usually two by 10 or two by 12 lumber that supports one side of a deck and attaches flat to the wall of a house after removing a section of siding.
It only weighs 100 pounds it is a ledger board a front plate and eight 2x4 rafters sitting on two 4x4 posts.
Use an impact wrench to drive inch diameter galvanized lag screws with washers through the ledger and into the sill of the house.
Never install a ledger board over the top of siding no matter what you hear this can weaken the connection.
These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim.
Get 4 inches of the flashing under the bottom of the siding.
In order to install the ledger board you usually need to remove the house s siding.
Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
Drill 1 2 inch holes through the ledger board into the planks between joists.
