How To Attach A Wooden Awning To A House

They are made out of vinyl canvas or solution dyed acrylic.

How to attach a wooden awning to a house.

If you want to hang something from your vinyl siding don t even think about drilling through it to attach a hook to the sheathing. This renders the siding vulnerable to moisture and voids the warranty even if you seal the hole. 8 inches in this case. Wall space needed for attaching.

Need some shade in your garden. Remove the shingles or siding in the area identified for the header board. They are in essence oversized swatches of water resistant fabric connected to a frame and attached to your house or some other structure. Determine the beam size.

Re check for level and then drill lag screw or bolt pilot holes through the ledger and into the house s framing. I cut one end of each 10 rafter with a 2 12 pitch cut 9 46 degrees and attached it to the 2x4 ledger with 2 galvanized wood screws. Take off enough covering to expose the wall sheathing or decking and show the nails used to fasten it to studs or trusses. Once the rafters were in place and secured to the 2x4 ledger and the 4x6 beam i measured from the house along the top of one of the end rafters and made a mark at 9 9.

Temporarily nail or brace the ledger in place positioned and leveled at the desired height. Attach the ledger with 1 2 inch diameter lag screws or bolts every 16 inches or as specified by local building codes. Awnings need approximately 6 to 12 inches of open heightwise wall or roof space to be installed. Choose a roof pitch 3 12 and roof structure 2x6.

Larger patio awnings may require permits or permission from the zoning board. Calculate the sightline clearance height about 6 feet 2 inches in this case. Work from the view back not from the house out. These awnings only need one attachment to the house on the wall.

Leave the decking or sheathing in place. This awning from primrose is just the job available from primrose. There are at least three alternative ways to do it.